How to Do Copperplate Calligraphy With a Dip Pen

CalligraphyMedium12:2010 stepsPart of Crafting for BeginnersBrowse more →
The finished result: How to Do Copperplate Calligraphy With a Dip Pen
Also in:Crafts

By Show Me Step by StepPublished

Based on a video by Loveleigh Loops | Calligraphy & iPad Lettering.

Copperplate is the formal, flowing script you see on old letters and wedding invitations. Every letter has fine hairlines going up and thick shaded strokes coming down. You make that with a pointed dip pen, ink and nothing else. This tutorial follows the Copperplate introduction from Loveleigh Loops, which covers the pen, the guide lines and the seven strokes every letter is built from.

How to do copperplate calligraphy: the short version

  • Fit a pointed nib in an oblique holder.
  • Write on a guide sheet with a 55 degree slant.
  • Dip the nib so ink covers the vent hole, then tap off the extra.
  • Go up light for a hairline. Press on the way down for a shade.
  • Drill the seven fundamental strokes before you write letters.

What you need to start

An oblique holder has a metal flange that holds the nib out to the side. That puts the nib on the 55 degree slant without twisting your wrist. Right-handers usually find it easier than a straight holder. A Nikko G nib is a common first nib because it is firm and forgiving. Sumi ink, like the bottle in the video, flows well and dries a deep black. Pour a little into a small jar so you do not dip into the whole bottle.

Paper matters more than people expect. Cheap copy paper is fuzzy and the nib catches and bleeds. A smooth, heavy laser paper or a calligraphy pad keeps hairlines crisp.

Getting a new nib to hold ink

New nibs come with a thin coat of oil to stop rust. Ink beads up and slides off. Wipe the nib with a little rubbing alcohol or dish soap and water, then dry it before the first dip.

Pressure is the whole trick

A pointed nib has two tines that meet at a point. Press down and they spread, laying more ink. Lift and they close to a hairline. So thin up, thick down. Never press on an upstroke. The nib can dig into the paper and spray ink. Build pressure slowly into a shade and release it slowly at the end, so the swell looks smooth and not like a blob.

Where the strokes show up in letters

  • A u is two underturns with an entrance stroke.
  • An n or m starts with overturns.
  • a, d and o are built on the oval. An e is half an oval.
  • l, k, b and h use the ascending stem loop. g, j and y use the descending one.

The exit of one letter is the entrance of the next. That shared hairline is what joins the word together.

Common problems

  • Railroading. Two thin lines with a gap on a shade. The nib ran dry. Dip more often.
  • Blobs at the start. Too much ink. Tap the nib on the jar rim.
  • Nib snags on upstrokes. You are pressing, or the paper is rough.
  • Letters lean every which way. Line each shade up with the slant lines on your guide sheet.

More calligraphy to try

Want to warm up with a pencil first? Try how to learn calligraphy or faux calligraphy. Compare the broad edge calligraphy pen, and once your strokes are steady, address a card with envelope calligraphy.

What you'll need

Step-by-Step Guide

10 steps · about 12 minutes.Check off each step as you go and your progress saves automatically.

1

Hold the Oblique Pen Holder With the Pointed Nib

0:24
Step 1: Hold the Oblique Pen Holder With the Pointed Nib - How to Do Copperplate Calligraphy With a Dip Pen

Copperplate uses a pointed pen. The holder in the video is an oblique holder. The brass flange on the side holds the nib off at an angle, which helps you write on a steep slant without bending your wrist. Slide the nib into the flange so it sits snugly and points along the line of the holder. Hold it loosely, the way you would hold a pencil.

Tip

If the nib wobbles, gently squeeze the flange so it grips a little tighter.

2

Press the Pointed Nib to See the Tines Spread

0:57
Step 2: Press the Pointed Nib to See the Tines Spread - How to Do Copperplate Calligraphy With a Dip Pen

Look closely at the nib. It is made of two tines that meet at a point. When you press down, they separate and lay a wider line of ink. When you ease off, they close again and the line goes thin. That change in width is what makes calligraphy look like calligraphy. Thin lines are hairlines. Thick ones are called shades.

Tip

Practise the press and release on scrap paper with no ink to feel how little force it takes.

3

Read the Copperplate Guide Sheet Lines and 55 Degree Slant

3:00
Step 3: Read the Copperplate Guide Sheet Lines and 55 Degree Slant - How to Do Copperplate Calligraphy With a Dip Pen

Write on a guide sheet. The baseline is where letters sit. One space up is the header line, and the gap between them is the x-height. Above are the first and second ascender lines, and below are the first and second descender lines. The slanted lines run at 55 degrees to the baseline. Most people write Copperplate at that angle.

Tip

Print a free guide sheet and slide it under thin paper, or rule the lines lightly in pencil.

4

Dip the Pointed Nib Past the Vent Hole in the Ink

3:50
Step 4: Dip the Pointed Nib Past the Vent Hole in the Ink - How to Do Copperplate Calligraphy With a Dip Pen

Pour some ink into a small jar beside your paper. You will redip often. The nib has a small hole called the vent. Dip deep enough that the ink covers it. Then give the pen a small shake or tap it on the rim. That gets rid of the extra so the first stroke does not start with a blob of ink.

Tip

Wipe a new nib with rubbing alcohol first. Factory oil makes ink slide off.

5

Write the Copperplate Entrance Stroke as a Hairline

4:37
Step 5: Write the Copperplate Entrance Stroke as a Hairline - How to Do Copperplate Calligraphy With a Dip Pen

The fundamental strokes come before any letters, because every letter is made from them. Start with the entrance stroke. It is a hairline that starts at the baseline and rises to the header line. Keep the pressure off the whole way. As it reaches the header, it curves to run parallel with the 55 degree slant.

Tip

Upstrokes are always light. Pressing on the way up makes the nib dig in.

6

Write the Copperplate Underturn and Overturn

5:18
Step 6: Write the Copperplate Underturn and Overturn - How to Do Copperplate Calligraphy With a Dip Pen

The underturn is shaped like a U. Press as you come down the slant, ease off at the bottom, and swing back up thin. The overturn is the opposite. Go up thin, curve over at the top, then press into a thick stroke on the way down. Write each one between the baseline and the header line.

Tip

Make the round part of each turn the same width. That is what keeps letters even later.

7

Write the Copperplate Oval and Compound Curve

5:57
Step 7: Write the Copperplate Oval and Compound Curve - How to Do Copperplate Calligraphy With a Dip Pen

Start the oval at the top. Build pressure slowly as you come down, so the shade swells, then release to a hairline and curve up and around to close it. The compound curve joins an overturn and an underturn. Go up thin, press down thick, and finish by going back up thin. So far every stroke fits inside one x-height.

Tip

Release pressure gradually. A sudden lift leaves a square end on the shade.

8

Write the Copperplate Ascending Stem Loop

6:28
Step 8: Write the Copperplate Ascending Stem Loop - How to Do Copperplate Calligraphy With a Dip Pen

The ascending stem loop is taller. Start at the header line and go up thin toward the ascender lines. Loop around at the top, then come down with pressure for a long thick shade that lands on the baseline. Keep the downstroke straight and lined up with your slant lines. This is the stroke behind letters like l, k and b.

Tip

Keep the loop narrow. A wide loop makes tall letters look like they are tipping.

9

Write the Copperplate Descending Stem Loop

6:58
Step 9: Write the Copperplate Descending Stem Loop - How to Do Copperplate Calligraphy With a Dip Pen

The descending stem loop mirrors the ascending one. Start at the header line, but go down. Because you are going down, press for a thick shade. Carry it all the way to the second descender line, then curl around and come back up as a hairline. You will use this stroke for letters like g and j.

Tip

Redip before long strokes like this one, so the ink does not run out halfway down.

10

Check Copperplate Strokes for Slant and Even Spacing

11:56
Step 10: Check Copperplate Strokes for Slant and Even Spacing - How to Do Copperplate Calligraphy With a Dip Pen

Look at your row of strokes. The gaps between strokes should all match. Every shade, the thick part made going down, should run parallel to the 55 degree slant. Draw slant lines and spacing marks over a practice row with a fine pen to check. When one is off, that is what the printed guide lines are there to fix.

Tip

Fill a page with one stroke before moving to the next. Consistency comes from repetition.

How to Write in Blackletter (Gothic Calligraphy)

Keep going

How to Write in Blackletter (Gothic Calligraphy)

Products Used

The Checklist

How to Do Copperplate Calligraphy With a Dip Pen

Tools
4
Materials
3
Steps
10
Video
12 min

Tools we recommend

Your Guide

Loveleigh Loops | Calligraphy & iPad Lettering

As an Amazon Associate we earn from qualifying purchases. Links on this page may be affiliate links - clicking them and buying doesn't change your price, but helps support Show Me Step by Step.

Tags

Sunday How-To

New calligraphy tutorials, every Sunday

One short email with the week's best step-by-step guides. Free, no spam, unsubscribe anytime.

Did this work for you?

What's next

Weekly Digest

Liked this calligraphy tutorial?

Pick the categories you want to hear about. Weekly digest of new step-by-step tutorials. No spam, easy unsubscribe.

Send me tutorials about

We only email about new tutorials. Easy unsubscribe anytime.